News

In coöperation between Euro-Techniek and Mikrocentrum a training course for press operators was started. This course is based on a
Eef van Berkel (far right on picture), Engineer at Euro-Techniek, joins the BBL-4 course “engineering technician” at ROC Tilburg. Currently,
In the last year, a lot of effort has been forwarded to comply with all the requirements for the new
The special interest magazine pays attention to Euro-Techniek!Reporter ing. Jan Wijers has visited us, and wrote a nice recommendation for
In the recent months a large part of the colleagues has followed a course on drawing interpretation and parts measurement,
At the foto, one gets a good mpression from the Holland stand in the “Industrial supply” Hall 4, where we,
A number of employees from both toolshop and stamping department have been trained by Produsoft in the use of VISICAD.
At the same time as the relocation of our existing wash plant (degreasing equipment), we also installed an additional wash
With our milling machines, after 17 years we have send-off our Ferrari B17 und we have replaced this machine by
In the middle of last year, we have bought an additional Kaiser 125 Ton press, and this press is overhauled
The new cleanroom has been delivered. It is 4 times larger than the old one, approximately 100 square meters ISO
In our toolshop we have invested in a Haimer Power Clamp Preset NG in order to mount milling cutter in